How to Fold Origami Balls

You are viewing the article How to Fold Origami Balls  at Lassho.edu.vn you can quickly access the necessary information in the table of contents of the article below.

With a square piece of paper and a little patience, you can fold a three-dimensional sphere or cube, then blow it up into a small balloon. In fact, you can even fill the ball with water and craft a “water bomb”!

Table of Contents

Steps

Create wings

Fold the square paper in half in two diagonals in the middle. The fold will form an “X” on the paper. ^[1]

• You are free to add a decorative pattern on the outside of the paper, which will appear when you fold it.

Fold the paper in half. Fold the paper in half by folding the bottom and top edges of the paper together.

Fold the top right corner in as shown. Fold in the same way with the other corner to form a triangle. Firmly press the folds. ^[2]

Fold the wings to the top of the triangle. Flip to the other side and do the same to make a rhombus.

Tuck the wings into the crease slot

Fold the right and left corners to the center of the rhombus. Flip to the other side and do the same.

Tuck the loose wings into the fold slot you just created. Fold in the small triangles on each loose wing, then tuck them into the folds. Do the same with all four loose wings.

• If you find it difficult to insert the wings into the slots, use tape to secure them to the folds.
• You can also use a pencil to open the slots easily, avoiding damaging the wings.

READ More:   Connie Chung

Flip the folded shape over to the end without any wings or folds. You should see a small hole in the center top of the four wings.

Blow air into the small hole . The balloon needs to be inflated – just make sure the folds are snug.

• You may also need to loosen the folds a bit to make the ball rounder.
• To make a water balloon, you can slowly pour water into the balloon through the hole until it is full. ^[3]

Advice

• When inserting the wings into the slots, you do not have to tuck them in until the wings are completely tucked into the fold. Just insert half of the wing is fine.
• If you can’t make a nice ball the first few times, don’t worry. Simply get a fresh sheet of paper and start over.

Warning

• When you throw a water bomb, be careful not to throw it in the face of another person, as it can seriously injure the person.
• Be careful not to cut your hand by the paper.

Things you need

• A square piece of Origami paper
• Water (optional)

With a square piece of paper and a little patience, you can fold a three-dimensional sphere or cube, then blow it up into a small balloon. In fact, you can even fill the ball with water and craft a “water bomb”!

READ More:   How to Kiss Your Boyfriend and Get Him Excited

Thank you for reading this post How to Fold Origami Balls at Lassho.edu.vn You can comment, see more related articles below and hope to help you with interesting information.

Related Search: